Industry-news

• 
  What are the differences in the applicable scenari

  26-05-22

  There is no absolute difference between soft tooth surface and hard tooth surface reducers, the core difference lies in the "adaptation difference". Their applicable scenarios are mainly determined by load size, operating speed, accuracy requirements, and budget costs. In order to give you a more intuitive understanding of the difference between the two, the following is a detailed comparative

  READ MORE
• 
  What are the differences in maintenance methods be

  26-05-22

  Soft tooth surface reducers and hard tooth surface reducers have significant differences in maintenance focus due to differences in gear material, hardness, and load-bearing capacity. Soft tooth surface reducers are more inclined towards basic daily protection, while hard tooth surface reducers have extremely high technical requirements for lubrication and assembly accuracy. The following are t

  READ MORE
• 
  What is the impact of motor power on load matching

  26-05-21

  The motor power has a decisive impact on the load matching of ZSC gear reducers. ZSC gear reducers are commonly used in heavy machinery such as cranes and winches. Improper power matching not only affects equipment operation, but also directly damages the reducer. The specific impact is mainly reflected in the following two aspects: 1. The motor power is too low ("small horse pulling big car

  READ MORE
• 
  How to achieve precise matching between ZSC hard t

  26-05-21

  When selecting motors for ZSC gear reducers, it is recommended to follow the following core matching logic in order to minimize or reduce motor power: 1. Power matching formula: The rated power of the motor should meet the following requirements: motor power ≥ (load power x safety factor) ÷ reducer efficiency. Note: ZSC is commonly used in impact load scenarios such as lifting, and the recom

  READ MORE
• 
  How to Reduce Speed: The Influence of Environmenta

  26-05-20

  The ambient temperature (especially low temperature) has a significant impact on the output torque of the S47 gearbox (belonging to the KS47 series helical gear gearbox). Under low temperature conditions, the viscosity of lubricating oil will sharply increase, leading to increased internal mechanical friction and transmission losses, thereby causing a decrease in output torque. To reduce the ne

  READ MORE
• 
  How to determine the safety factor when selecting

  26-05-20

  When determining the safety factor (usually also known as service factor or operating condition factor) for the selection of S-series reducers, it is not enough to simply give a fixed value, but rather to comprehensively evaluate it based on specific actual operating conditions. Generally speaking, the range of safety factor values is usually between 1.2 and 2.5. The following are several core

  READ MORE
• 
  What factors need to be considered when selecting

  26-05-19

  The ZQ series soft tooth surface reducer is a typical universal industrial reducer, usually used in light load, low-speed, and cost sensitive scenarios. When choosing the material for its casing, it is important to consider the following core factors: 1. Load characteristics and shock absorption performance The ZQ series reducer is commonly used in equipment such as cranes and conveyors, and

  READ MORE
• 
  How to determine whether the gearbox frame needs t

  26-05-19

  To determine whether the gearbox frame needs to be repainted, a comprehensive evaluation can be conducted from four dimensions: the degree of corrosion on the appearance, the damage status of the paint film, the operating environment requirements, and the equipment maintenance cycle. 1、 Observe surface corrosion and rusting conditions This is the most intuitive criterion for judgment: Red

  READ MORE
• 
  How to solve the problem of internal gear transmis

  26-05-18

  The solution to the internal gear transmission system faults of CJY series reducers requires corresponding measures to be taken for specific types of faults. Based on common problems, the core solution is as follows: 1. Gear wear or fatigue fracture Reason for wear: Alternating load causes fatigue crack propagation at the tooth root, ultimately leading to fracture; Or fracture may be caused

  READ MORE

CATEGORIES